Hi all - looking for laser software (GUI) that can run a3200 motion control. What Id like to have is a routine that can create a trench or V shape cut path. (That is, focusing on top of work for a number of passes then dropping down for a few passes and repeat until through the work. - the cut would look something like the top view of a bowling pin set up. This seems to be the most efficient process for cutting through super hard non conductive material. The material varies in thickness from 300um to 2mm thick so the V would need to be variable in height but always maintain a 3 degree (6 included) angle. Not familiar with any laser control software here -so not sure where to start. Any help is appreciated.

Similar Threads: