lost all communication


Results 1 to 2 of 2

Thread: lost all communication

  1. #1
    strawhat57's Avatar
    Join Date
    Oct 2018
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default lost all communication

    no usb either computer or udisk also ethernet
    working fine then died
    ruida controller
    newbie any suggestions appreciaed
    thanks



  2. #2
    Member
    Join Date
    Apr 2006
    Location
    usa
    Posts
    108
    Downloads
    0
    Uploads
    0

    Default Re: lost all communication

    You must make sure to install the USB drivers.
    I have found that connecting the USB driver is not always a perfect solution. The computer can become clogged with alocating serial port numbers so high that the software doesn't recognize the USB port number. Try a different computer.

    Make sure the USB cable is good.
    Make sure the electrical source does not have distortion from welder, powder coating system, or otherwise... I use a TripLite LC-1800 power line conditioner.

    If the USB cable fails and USB disk fails... it might indicate that the power supply is failing.. or the controller is going bad.

    Thank You,
    Ray Scott



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

lost all communication

lost all communication