- Fusion 360 to Planet-CNC MK3/4 controller POST PROCESSOR help
-
*Registered User*
Fusion 360 to Planet-CNC MK3/4 controller POST PROCESSOR help
Newbie here trying to find a way to generate reliable G-Code from Fusion 360 to be loaded to my PLanet CNC MK/3/4 controller. I have tried about 15 different Post Processors but either they run into multiple errors are generate G-Code that has a multitude of manual corrections that must be made. Anyone out there have a solution?
-
-
Activation process
Re: Fusion 360 to Planet-CNC MK3/4 controller POST PROCESSOR help
Last edited by jk40001; 11-24-2018 at 09:28 PM.
-
Activation process
Re: Fusion 360 to Planet-CNC MK3/4 controller POST PROCESSOR help
I am also looking for a post processor for the same setup. Did you find a good one? Please let me know.
-
Member
Re: Fusion 360 to Planet-CNC MK3/4 controller POST PROCESSOR help
I am using EMC2-Lnux pp and works ok until the zero Z axes is on top of the object, now I have modified the PP to stop writing G28&G53 codes. Only attrention is nedded to put the Z axe higher from object.
Still this is not job done, because I moastly use Z on table (using vaccum table), and need for aditional futures like start vacc, cooling, etc.
- Fusion 360 to Planet-CNC MK3/4 controller POST PROCESSOR help
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules