larken system 400

[william11]

hi new to cnc i have recently purchased a larken system 400 router has any members any information on them and what software they will work on thanks for your time

Similar Threads:

• Need Help! upgrading a Larken System 600ls
• Used Larken Router Please
• Larken is still
• New Used Larken 24/24R
• Larken

[Al_The_Man]

LCAM for DOS and Windows, I believe Larry has them for download off the Larken site?
Al.

[Larken]

Can i ask, who did you buy it off in the UK ? I think I've only shipped 2 system 400's to the England. Can you post a picture of the inside of the control box?

larry K

[william11]

Larry are you getting my emails, I have tried to PM you but says your inbox is full

Can you please get back to me

Thanks William

[Larken]

I erased a bunch , but email is the best.
LK

[Ron Thompson]

I just acquired a Larken System 400 LS with an ATC. Can anyone point me the a photo of the ATC mounting? This one is off the machine and it is running Mach3 and Gecko drives.
Thanks!

[Larken]

I built those machine with the TC in 2000- 2001 . It ran on Lcam that had toolchanger controls integrated.
The Mach3 must have been put on later, you are on your own with that .
One mistake i made was not putting an oiler in the airline, so the air cylinder tended to sieze up with moisture in the air.

Larry K

[Ron Thompson]

Thank you sir! Is the air cylinder you spoke of to release the tool?

[Larken]

Thank you sir! Is the air cylinder you spoke of to release the tool?

Yes its in the top of the spindle

Larry