Is that the DOS version or Windows?
Al.
I am so excited, I just bought this system complete for $3,500.00 and I hope to go get it tomorrow.
---Edit--- Here is what the add Stated
66"x55" Larken Automation CNC System 50 machine
66"x55"
Larken CNC machine everything on machine table and machine included. Fully functional
complete with documents which are also on website
starcam program on computer
3-D digitizer probe
computer comes with software to use the machine
assortment of bits
z-axis controller
3 axis controller
delivery and setup extra
more info on parts, software....etc
---End of Edit---
I will also be selling the Solsylva Table that I was building with all the electronics I have for it.
Thanks
Doug
Similar Threads:
- Using PLM-II Linear system without support in 2 axis system
- Gecko G540 Bare Bones System (Enclosure, 48v 8.3a Power Supply, Cooling System)
- Gecko G540 Bare Bones System (Enclosure, 48v 8.3a Power Supply, Cooling System)
- Need Help!- Mitsubishi system Meldas 60/60s how to set G54/G55 tools coordinator system
- Need Help!- Converting DSP controller system to Mach based system.
Last edited by DouglasMorency; 02-11-2013 at 06:08 PM.
Is that the DOS version or Windows?
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Thats a machine we built in 1993-1994, I think its been upgraded to Starcam, but I have a new USB version or Starcam if you ever want to upgrade.
I sent Lenny down to get you going. Was he a good help ?
Larry K
Manufacturer of CNC routers and Viper Servo Drives
www.LarkenCNC.com and www.Viperservo.com
Hi Larry,
It does have starcam, and I am very happy with it.
I met Lenny at his shop and he was amazing in helping me learn about the software.
I need to rework the wiring on the routers as the XY Home axis is in the Back left side, instead of the front left side, also I will need to replace the X Axis limit switch, as it is broken, other then that this is an amazing table.
I am planning on switching the MDF worktop with 1x4 planks, so that I can place clamps imbetween the boards.
Thanks again
Doug