Shizuoka AN-S - Page 2

Page 2 of 2 FirstFirst 12
Results 21 to 23 of 23

Thread: Shizuoka AN-S

  1. #21
    Member
    Join Date
    Apr 2011
    Location
    USA
    Posts
    20
    Downloads
    0
    Uploads
    0

    Default Re: Shizuoka AN-S

    I do not have a source for one. I planned to measure/engineer one and then machine it. I'll make several when/if I get it done. I would appreciate the opportunity to buy one if someone else goes through the exercise. Measurements of a good one would be very much appreciated, too.



  2. #22
    *Registered User*
    Join Date
    Mar 2015
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Re: Shizuoka AN-S

    How did you pull the Y axis ball screw? Did you have to remove the knee? I am rebuilding the X/Y axis on a Shizuoka AN-S mill. Thanx!!



  3. #23
    Member
    Join Date
    Apr 2011
    Location
    USA
    Posts
    20
    Downloads
    0
    Uploads
    0

    Default Re: Shizuoka AN-S

    So my belt finally popped! It seems like I have to wind the screw that moves the yoke for the variable width pulley all the way out and then the variable pulley assembly should pull all the way off. Happily it seems to have slid off the end of the splined shaft down into the gearbox. I too have sheared the nylon back gear if anyone has a source. I fear I'll have to reverse engineer it and machine one... It figures I broke the belt an hour after everyone closed for the weekend.



Page 2 of 2 FirstFirst 12

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Shizuoka AN-S

Shizuoka AN-S