Recently I got my first cnc mill Kitamura mycenter1


Results 1 to 2 of 2

Thread: Recently I got my first cnc mill Kitamura mycenter1

  1. #1
    Registered
    Join Date
    Oct 2013
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Recently I got my first cnc mill Kitamura mycenter1

    The machine is running ok but I have a question seeking for exper tips . The air seems like leaking from the top or somewhere near the spindle. I have a 1.7 hp 28 Gallon air compressor , and it cannot handle the air leak. Every time I plugged the air in the machine it would drain so fast the compressor would run and run on forever.

    Can someone help me out please as this is my first cnc mill and it’s pretty old like 1997.



  2. #2
    Member Seven30's Avatar
    Join Date
    Jul 2022
    Posts
    13
    Downloads
    0
    Uploads
    0

    Default Re: Recently I got my first cnc mill Kitamura mycenter1

    Im surprised you got no responses. Your mill probably has the 10k spindle. There is an air-oil mister that supplys air to the spindle. About 10cfm !!!

    There should be a solenoid to shut it off a couple of minutes after spindle stops. I believe the solenoid is located behind tall panel at rear of machine.
    It could be stuck or perphaps bypassed.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Recently I got my first cnc mill Kitamura mycenter1

Recently I got my first cnc mill Kitamura mycenter1