Mycenter 2 problem table change move of Y and X as


Results 1 to 2 of 2

Thread: Mycenter 2 problem table change move of Y and X as

  1. #1
    *Registered User* Koen1's Avatar
    Join Date
    Oct 2018
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Mycenter 2 problem table change move of Y and X as

    Hi , I recently bought a old (1987)mycenter 2 with table change running with a Fanuc 11m controller.

    I had it running and producing some small aluminium parts.
    Then I went in to the table change mode:

    O9009(Pallet2)

    G0 G30 X0
    G28 Y0 M62
    G30 Y0 M63
    M99


    The table moved to the place where it should pick up the table.
    Then I got an error EX 05 this was from the hydrolik motor.
    I had to surch for this. So I turned off the power.


    This is where I went wrong I guess.
    Now the X and Y axis wont move anymore. Z Axis stil moves.


    Hope some can help me reset this.

    A Manual of this Kitamura would be much appreciated as well.



  2. #2
    *Registered User* Koen1's Avatar
    Join Date
    Oct 2018
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Re: Mycenter 2 problem table change move of Y and X as

    I found out that the pickup arm of the APC is not in his home position anymore.
    If I push the switch for the home position it´s all working again.
    Big question now. How to get the arm back in it´s home position?

    Hope someone is able to tell me this.

    regards Koen



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Mycenter 2 problem table change move of Y and X as

Mycenter 2 problem table change move of Y and X as