- What year is this Kit My center 1 Fanuc 0M
-
Registered
-
-
Member
Re: What year is this Kit My center 1 Fanuc 0M
Hard to say without more info on the control, probably 91-94 vintage.
Sent from my A3-A20FHD using Tapatalk
-
Registered
Re: What year is this Kit My center 1 Fanuc 0M
I was hoping someone might have one like it or know from the control panel ? I will be picking it up tomorrow so I should find out some more info.on it. I purchased it in an auction site unseen and I won ? Hopefully its a good one.
The auction was an asset liquidation and I don't really think they knew much about the stuff the were auctioning ? They did not go into any detail about any of the equipment as to the condition if it was running or not.
If anyone has any info.or manuals and such they can share I would be very grateful
-
Registered
Re: What year is this Kit My center 1 Fanuc 0M
It is an October 89 machine got all manuals and parameters with it. Its been in storage for a while so I am sure the battery has died. How hard is it to input the parameters back in and where can I find info.for that ?
-
Registered
-
Registered
Re: What year is this Kit My center 1 Fanuc 0M
Went to the auction to buy one machine but came home with two consecutive serial numbers. - - - 95, - - - 96 the 96 looks to be in better shape has new screws as well. plan to get them both up and running again.
Both are October 89 Fanuc 0M-B control AC servos and digital. Not sure on the spindle speed I think they are the 1300 K spindles.
-
Member
Re: What year is this Kit My center 1 Fanuc 0M
Parameter input is just time consuming. Probably 8k spindles, high rpm spindles were not super common in 89. Most builders were in that 6-8k range back then.
Sent from my A3-A20FHD using Tapatalk
-
Registered
Re: What year is this Kit My center 1 Fanuc 0M
Need HELP have powered up my machine and have Alarm code 531 have tried the instructions in the manual and have not been able to get it fixed. Its says to enter G23 How can I enter G23 to fix the problem ?
Thanks
-
Member
Re: What year is this Kit My center 1 Fanuc 0M
Did you get them running. How is it going?
- What year is this Kit My center 1 Fanuc 0M
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules