I think, usually is 9020 program with tool change sequence.
The led display does not seem to move away from "1" when I advance carousel. When in MDI mode, do "M6 T2" does NOTHING. Just did a master reset (accidentally) and wiped parameters - just put them all back in. I understand there is a tool macro that is executed? I copied from another machine - not sure where supposed to go #9001? 9000? 9020?
Can anyone advise please?
Similar Threads:
WWW.RAIDGEAR.NET - FFC cables, foam headset replacement parts, and other gadgets.
I think, usually is 9020 program with tool change sequence.
9001
I am also having the same exact issue, not sure what to do from this point on. Can someone please shed some light on this topic please? My machine is a 1983 Kitamura Mycenter1 with Fanuc 3M-C control VMC
Hola,soy nuevo en el foro. Le comento que tengo una KITAMURA MYCENTER 1 FANUC OM,El cual me esta dando dolores de cabeza últimamente. Cuando enciendo la maquina la luz INDEX del pulsador permanece intermitente y nose como solucionarlo, soy de Mendoza argentina y aquí todavía no encuentro quien lo pueda solucionar. Me urge mucho poder repararla, cualquier comentario con respecto al tema me seria de gran ayuda. Graaacias
You have pictures of your team's problem, I can support you:
antonio_aries_94@hotmail.com
The Kitamura Mycenter 1 w/Fanuc 3M control does not use a 9001-macro for the ATC. It is completely controlled by relay logic.
* Confirm that the ATC is retracted
* Confirm that the ATC is UP
* Confirm that the spindle tool is CLAMPED
* Confirm that the ATC TOOL POCKET opposite the spindle is the number shown in the LED window.
Note: The pocket opposite the spindle must always be empty.
Command Txx M06; in MDI. What happens?