- Kit tool changer arm stuck in mid stroke
-
Registered
Kit tool changer arm stuck in mid stroke
Another problem with our Kit MyCenter2. While doing a tool change our arm has gotten stuck in the mid position, and I can not figure out how to reset.
The machine will not let me zero return axis when I first fire it up. Also the screen displays the letters MT after I try to excute an M6
Does anyone know how to reset the tool change arm?
thanks in advance for any input!
Similar Threads:
Last edited by new2kit; 08-24-2010 at 08:59 AM.
-
-
Registered
This is a tricky one to fix.
Make sure your Z axis pulse in coder is working. Make sure the tool arm is not stuck on the spindle nose. If so you will have to pick the Z up a bit.
You will have to go into your parameters and also trick the tool change position proximity switches that the tool change operation is in its home state.
(1) On my machine I have to change address (467) from value 0 to value 1. The NC will alarm that’s OK.
(2) Stick a steel object in where the proximity switch is located in the tool change mechanics. The LED on the switch should turn on when the switch is closed.
(3) Above the tool change ARM there will be another proximity switch you will need another steel object to close that switch as well. Use something long don’t want to lose a finger.
(4) Put the machine in Jog mode and jog the arm home.
-
Registered
If you go into maint mode you should be able to jog the arm back into position. Check to see if there are chips around the home position sensor that makes it think it is in home pos.
-
Registered
Tape a penny on the prox switch and jog the arm through the sequence back to home. Get the book out for the proper sequence steps. You may have to reset the tool numbers back to normal after you get done with the mechanical mess.
-
Member
Re: Kit tool changer arm stuck in mid stroke
The ATC arm is stuck on my machine, but I can't figure out how to get the machine into maintenance mode to jog it. I have all of the manuals, but I am not seeing anything about maintenance mode.
-
Member
Re: Kit tool changer arm stuck in mid stroke
Was there every a resolution to this?
-
Member
Re: Kit tool changer arm stuck in mid stroke
To get into maintenance mode
MDI
AUX 2 soft key
ATC1 soft key below screen
page down
highlight maintenance mode(will put machine in alarm status)
write
yes
handle mode
atc switch(bottom right of panel) to "tool change"...
Make sure the head is not in the way of the tool changer arm
Hold the execute button down to move the arm into position.
If you have to reverse direction hold "feed hold" while you press execute (I have never actually done this myself)
move arm back to home position
MDI mode
highlight maintenance
write
yes
reset
I still don't know where my alarm was coming from. It went away somewhat randomly when we messed with this button that is on the side of the machine behind the ATC carousel.
-
Member
Re: Kit tool changer arm stuck in mid stroke
It seems that the machine was getting stuck mid tool change because the drawbar wasn't releasing quickly or completely enough, so when the piston pushed the arm down to swap tools, it was actually yanking the head down a few thousandths. The machine would abort the tool change, presumably to prevent the arm from hitting the head. I cycled tool clamp/unclamp over and over until it seemed to be working reliably. However, it still hangs up sometimes. I'm hoping it will do better once I get it into regular service. I was finally able to send a program over to the control today.
- Kit tool changer arm stuck in mid stroke
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules