- hypertherm 1000 hookup to plasma table
-
Member
hypertherm 1000 hookup to plasma table
I just picked up a used fastcut plasma table. I have a g3 1000 that I'd like to hook up to it. Looks like previous owner had a powermax 45. There are two wires hanging off the bottom that he had labeled j21 and j19, these are for arc voltage sensing and do go to the power supply according to previous owner. Is there a schematic for arc voltage so I can get these hooked up properly?
Similar Threads:
-
- hypertherm 1000 hookup to plasma table
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules