Need Help 45xp Please


Results 1 to 1 of 1

Thread: Need Help 45xp Please

  1. #1
    Lvcustomsigns's Avatar
    Join Date
    Nov 2018
    Location
    Las Vegas
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Need Help 45xp Please

    I have a 3 month old 45xp and it keeps throwing the gas fault and system fault code over and over. It will Fire and start to cut then about 5-6 seconds throw the codes and the torch will shut off but my machine will keep moving. I have checked all filters, ground, air pressure is good , wires are good and have reset the machine over and over. What else could it be? What a pain!!!



  2. #2
    Member memphisjed's Avatar
    Join Date
    Apr 2016
    Location
    Memphis
    Posts
    18
    Downloads
    0
    Uploads
    0

    Default Re: Need Help 45xp Please

    extend your machine initial purge cycle to blow out moisture from idle time. Do you have large enough air lines running to machine? Your pressure will show good on your pre regulator by the time you get back to check it, also your air dryer/oil separator might be clogged up. just the first things i would check.



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Need Help 45xp Please

Need Help 45xp Please