The electrode, and cover are ok?
The connector for high voltage (pilot arc) is clean?
Hi everybody . i have some issue with my pilot arc. there is some problem with 400xd hypertherm.
when i run the machine .the torch goes down touch the material making gas test and the machine doesnt cut the material
no pilot arc and cutting arc .what does that cause about my problem. please help mee.
Similar Threads:
- New Machine Build- Pilot Pro By PDJ
- Pilot Pro Ex ???
- PDJ Pilot Pro
- THC with HV/HF pilot arc??
- 3yr old Pilot
The electrode, and cover are ok?
The connector for high voltage (pilot arc) is clean?
Check mass connector
i have attached you the video that you could figure it out .Thank you for your support...
Pilot arc looks fine, but stops very quick. Check air pressure and filters. There may be aproblem with hv set.
i am gonna check it out . thank you for your coorperation and support.
It would be good you rechecked the electrical conections between table and machine and then checked the Open Circuito Voltage for sure.
Also check the parameters for pierce high.
i found the problem. the problem was in the hose some copper from the watertube. it has been stuck inside the oxygen hose.i removed it and there was no any problem....
Hi I have same problem with ht2000
Still can't figure it out,