Hurco KMB1 Retrofit Project FS
Hi All,
I purchased this Hurco mill as a retrofit project several years ago but have decided I'm not going further with it.
Items for the retrofit includes the following:
Three DG4S-16035 servo drives
Three BRKC-180 braking circuits
Three Braking resistors
One PMDX-107 Isolated speed control
One PMDX-126 Breakout board
The original servo encoders have been upgraded to US Digital E3 & E6. The original control circuitry and display have been removed. The power section is intact as original. There are three extra (X,Y,Z) servos and one extra spindle drive motor. In addition there are about 30 Kwik-Switch collet and tool holders of varying sizes.
I am located near Hagerstown, MD and the buyer will need to arrange loading and transport. I am asking $1,500 for all of it.
Thanks!
Dan
Similar Threads:
- Problem- Hurco KMB1
- YAHKMB1R (Yet Another Hurco KMB1 Retrofit)
- Build Thread- Hurco KMB1 Retrofit
- Need Help!- hurco kmb1
- Need Help!- Hurco kmb1
Reply with Quote
