- Hurco BMC 50 - stuck on machine configuration
-
-
-
Member
Re: Hurco BMC 50 - stuck on machine configuration
Not sure if this will help, but I had the exact same issue. Turned out to be stuck keys on the keypad.
(Assuming Ultimax 3 here) look at the PCB under the keypad. There is a flashing green LED bottom left of the board. If it's flashing like crazy at the config screen, you likely have a stuck button.
For me, the conductive silver pads under the membranes on the keypads are a bit oxidised. Hopefully a good clean will sort it out.
- Hurco BMC 50 - stuck on machine configuration
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules