- Hurco spindle brake problem
-
Member
Hurco spindle brake problem
Hurco MB3 shuts down and blows fuse when spindle brake released
-
-
Member
Re: Hurco spindle brake problem
I had a similar problem with a KM3 and added a time delay between brake off and spindle start. I also had to disassemble the brake cylinder and clean/reseal it. There was an amazing amount of crude in both of mine. Is it safe to assume that you have verified good pressure and flow to the brake cyl?
-
Member
Re: Hurco spindle brake problem
Electrical brake at the top of the motor. Disconnect the wiring to the brake and put a meter between the three wire to see if one winding is short. Then check each wire to ground.
- Hurco spindle brake problem
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules