Wierd Error

[Feri56]

VMX1 2007. This error is displayed: NO MOTION CONTROL BOARDS WERE DETECTED IN THE SYSTEM but in Control panel the PCI XMP Motion Controller is "working properly" !!!??? Verified 24VDC prezent at the RMB module.

Similar Threads:

• Need Help!- Wierd error
• Wierd CNC problems
• Had something wierd happen yesterday
• Wierd G31 system error - ideas?

[bloke]

Your 24v supplying the RMB module has gone/shorted to ground.

[Feri56]

24 Vdc is ok but the state of the six LEDs is as follows:
IN/LINK - off
IN/CYCLIC - blinking
OUT/LINK - off
OUT/RPT - off
FPGA - blinking
BOOT - on

[Feri56]

24 Vdc is ok but the state of the six LEDs is as follows:
IN/LINK - off
IN/CYCLIC - blinking
OUT/LINK - off
OUT/RPT - off
FPGA - blinking
BOOT - on

[bloke]

There is a listing available from Hurco that will tell you what the LEDs mean. You’ll also need to see what the LEDs on the sockets of the XMP card are doing too.

[Feri56]

The LEDs on the sockets of the XMP card are all OFF.