Hi all,
I have a hurco BMC 30 milling machine and when I go to move any of the 3 axis it gives a fault and shuts the control power off.
When it does this and I try and re-start it the solenoids in the tool changer start clicking.
I know when I can move it without faulting out because I can here the servos are energized but as soon as the solenoids click again and I try and move it, it will fault out again.
It did this several months ago but then quit and ran perfectly fine but now the problem is back.
I checked the outputs on the power supply and they seem to be all the correct voltage.
Any info would be appreciated
Thanks Rod
more information may help https://www.cnczone.com/forums/hurco...facturing.html
DJ, Thanks for the info I will do some more hunting today.
Well it started working again? I didn't solve anything but at least its back on line. Ran it through the warm up cycle several times with no problems. Thanks again for the info.
Rod