NO MOTION CONTROL BOARDS WERE DETECTED IN THE SYSTEM

[fsebascg]

Hi!!

Please I need help!!! recently I got a hurco vm1 2006 from USA, when I bought it, it was working. When it arrived to my country (Ecuador) the pandemic started so it was a long time turned off, recently I turned on and I charged the BIOS and I could start with the ultimax control v 2.36.01e/2.04.05i but the error "NO MOTION CONTROL BOARDS WERE DETECTED IN THE SYSTEM" appeared. I recieved help from an electrical technician and he told me the electronic of the machine is ok so I don't know which is the problem.
I have some diskettes one of them has a software upgrade a the others are optikeys.

Thanks very much for reading!!
Best regards,
Sebastian

Similar Threads:

• Looking into motion control/breakout boards and after recommendations
• Recommendations on motion control boards & Single Board Computer
• Motion Control Board Selection, any USA made boards with support?
• BoB & Motion Control Boards ?
• Newbie- DynoMotion K-Flop vs MicroKinetics MN400 Motion Control Boards

[cnc-exit]

Motion control are there please disconect wires. And then connect.

It is posible power suply fail

tadasdan@gmail.com
+37060022992

[sureyyasertasi]

i am having the same problem on my machine, i would be grateful if you could help