- Need Help!- hurco ultimax 2 help
-
Member
hurco ultimax 2 help
INPUT OVERFLOW! CHECK PROTOCOL! this is the message I get when i load the program on full handshake. I've tried changing the parameters, and i mean all of them. But nothisg seems to work properly. sometimes when i get the baud rate to 600. It runs but too slow, and now it wont even work on 600. What can cause the problem. Someone please help
Similar Threads:
-
-
Member
Re: hurco ultimax 2 help
Could anyone be so kind to help me out? The only solution for me was a 300 baud rate, but it takes 2-3 times more time to finish something because the code is loading too slow and the machine is waiting for it to load every so often.
-
Member
Re: hurco ultimax 2 help
...try setting Flow Control XON/XOFF (Software)
-
Member
Re: hurco ultimax 2 help
I've tried setting xon/xoff and it has worked for me before but for some reason, when i changed the laptop that loads to the machine, it's not working properly. I've also tried with other setting but no luck. When I set the baud rate to 2400 for example, The program loads only 10% of the machine memory and then it states "Input overflow", and stops every action.
- - - Updated - - -
I had to change the laptops because the old one died.
-
Member
Re: hurco ultimax 2 help
...USB to Serial adapters are sometimes the problem if, that is what you are using.
-
Member
Re: hurco ultimax 2 help
I am using serial to serial directly, and have tried 2 different lap tops.
-
Member
Re: hurco ultimax 2 help
Hello msavcic, I need help with the communication of a Hurco with Ultimax II, what is the process to upload an NC file to the Hurco after connecting it to the pc? Do I have to download any software?
- Need Help!- hurco ultimax 2 help
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules