- question about adjusting air flow valves on tool changer BMC30M
-
Member
question about adjusting air flow valves on tool changer BMC30M
I wonder if there is a written procedure for adjusting the air flow control valves on the tool magazine controls. Right now the magazine rotates too slowly and sometimes wont even move. but we just can't get the control valves right. they are not very responsive and one affects the other, etc The door is too slow, the whole magazine comes over too fast and hits hard at the stop, just need some guidance.. Thanks, Kaase
Similar Threads:
-
-
Member
Re: question about adjusting air flow valves on tool changer BMC30M
That year and name of your hurco because. Mainly it is from electric motor.
Išsi?sta naudojantis SM-G960F Tapatalk 4 Lt
- question about adjusting air flow valves on tool changer BMC30M
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules