- BMC 30 Help Needed please
-
Member
BMC 30 Help Needed please
Here goes !......BMC 30 problem.
Basically the Z axis will not settle. Constantly moving about 0.1 to 0.15.....
When i callibrate the machine, Z is not zero but 0.700
Also, if i press either Manual,Input,Auxillary or Review, the Z axis bounces and usually causes a Z Axis following error.
If left sitting for a while , the axis rumbles and bounces and invariably errors out.
So do i need a new encoder...or drive, or can i tweek anything to try correct it ?
It has somehow corrected itself before, and run perfectly for weeks, then out of the blue started this again.
Any help woulkd be much appreciated
Similar Threads:
-
- BMC 30 Help Needed please
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules