hurco vm10i changing lead in lead out by itself

Results 1 to 2 of 2

Thread: hurco vm10i changing lead in lead out by itself

  1. #1
    Member
    Join Date
    Jul 2014
    Posts
    163
    Downloads
    0
    Uploads
    0

    Default hurco vm10i changing lead in lead out by itself

    Hi weve got this machine on winmax and it changes lead outs mainly by itself sometimes. It happens mostly as Ive noticed, when there is a short lead out from an contour, for example, 2mm in normal direction. Or even when there are small radii in the contour, like R0.8, after which it has to continue in a straight line for couple of mm then lead out, it will create chamfer instead of radius. It had nothing to do with cam software or postprocessor, it is because of machine parameters and software. On other machines mainly fanuc or haas, the same program will run normally. If I add short 2mm normal lead out from a contour which ends as a straight line, it will make that straight line at an angle! If i change or prolong that lead out it will make it like it should be. Ive tried looking in machine settings and parameters but no luck in finding what is causing that behavior.

    Similar Threads:


  2. #2
    Member cnc-exit's Avatar
    Join Date
    Apr 2019
    Posts
    9
    Downloads
    0
    Uploads
    0

    Default Re: hurco vm10i changing lead in lead out by itself

    Tool diameter compensacion turn off , was to mesimilar. You use mastercam.

    Išsi?sta naudojantis SM-G960F Tapatalk 4 Lt



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

hurco vm10i changing lead in lead out by itself

hurco vm10i changing lead in lead out by itself

hurco vm10i changing lead in lead out by itself