va-40 Micron 8 troubleshooting

Results 1 to 2 of 2

Thread: va-40 Micron 8 troubleshooting

  1. #1
    Member MwTechInc's Avatar
    Join Date
    Nov 2021
    Posts
    7
    Downloads
    0
    Uploads
    0

    Default va-40 Micron 8 troubleshooting

    Looooog story short I had the ol girl starting up and running fine......albeit I still hadn't run any programs.

    Today she starts up but the drives wont go into ready state...nothing moves, will not home, zero ,nada.
    So using the side panel I start going down the list checking out stuff.
    They say" o" is no signal " 1" is a signal being sent

    so if my lube is sending out a "1" does that mean its Ok or does it mean calling for help??
    Lube is full.......

    Similar Threads:


  2. #2
    Member MwTechInc's Avatar
    Join Date
    Nov 2021
    Posts
    7
    Downloads
    0
    Uploads
    0

    Default Re: va-40 Micron 8 troubleshooting

    Well..............I have solved my problem...it was a parameter change i made...was trying to get the lower case symbols to work with the abs/inc key as the shift key...
    For some reason that messed up the start sequence??? who knows why.....

    Still would like to know about the 0 and 1



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

va-40 Micron 8 troubleshooting

va-40 Micron 8 troubleshooting

va-40 Micron 8 troubleshooting