hi i need some help, Im not to familiar with this control.I need to run a new program. the new program is already in the directory in the Hitachi seiki lathe HT 20j seicos j multi
need to call the new the program to run it .is anyone familiar with this control.
thank you
Similar Threads:
Could you help me? I just bought a Hitachi 23 j lathe and I have problems performing set 0 in z and x for a new program?
Could you help me? I just bought a Hitachi 23 j lathe and I have problems performing set 0 in z and x for a new program?
Send me a PM and I will assist
John
Hi John,
I was looking at a nice condition Hitachi Seiki HT20J with Seicos J Multi.
Not sure what control its based on but does your team still have parts/support for this
"classic" ?
Hello!
Yes, so the J series are based on Yasnac J300 - parts and knowledge are readily available; they are robust and I rarely have to work on them as the parts are more reliable and last longer than some other controls.
That is good to know! Is there anything in particular to watch for on the HT 20J?