Adjusting backlash on a VK 45 II

[viorel23cnc]

Hello,

How do I adjust the backlash on VK 45 2 with seicos M3 controller? I noticed that the Y axis has 0.06 mm backlash. The manuals I have don't show the procedure or how to interpret the mechanical compensation parameters.

Thanks

Similar Threads:

• Need Help!- Adjusting preload/backlash in these screw support bearings?
• Adjusting Y axis backlash Boss 6.1
• Adjusting Backlash Compensation on a Cen. 6
• Adjusting crossfeed backlash on Busy Bee
• Adjusting backlash on VF-OE

[shas595]

Hello,

How do I adjust the backlash on VK 45 2 with seicos M3 controller? I noticed that the Y axis has 0.06 mm backlash. The manuals I have don't show the procedure or how to interpret the mechanical compensation parameters.

Thanks

Hello!
It’s parameter 1833 for the backlash compensation on a Seicos MIII, goes in order of x,y,z

John


Sent from my iPhone using Tapatalk

[nikopoli]

Hello!
It’s parameter 1833 for the backlash compensation on a Seicos MIII, goes in order of x,y,z

John


Sent from my iPhone using Tapatalk

Please can you describe the procedure?

[Algirdas]

did you check if it's possible to eliminate mechanically ?

[nikopoli]

did you check if it's possible to eliminate mechanically ?

Yes but I have only 0,015mm and for this I think that the software corrections it's okay