- Heidenhain iTNC 530 No field angle ESTERMA LINEAR with absolute encoders
-
Member
Heidenhain iTNC 530 No field angle ESTERMA LINEAR with absolute encoders
Hello everyone
I am using ESTREMA LINEAR with Heidenhain iTNC 530 " Controller 422B"
There U axis scale broken LC 481 Than we buy compatible LC 485 and fixed
Now facing issue for U axis phase angle.
Please help for solution its 5 axis machine where X axis and U axis both parallel GANTRY axis and sync each-other .
So there MSG is "No field angle U axis"
How can set and calibrate for field angle for absolute scales.
Similar Threads:
-
-
Member
Re: Heidenhain iTNC 530 No field angle ESTERMA LINEAR with absolute encoders
Hi,
I checked the Heidenhain service manual, and apparently what is mentioned there is as follows:
18.1.7 Determining the field angle on linear motors, torque motors and synchronous spindles
If an encoder was replaced that is also used to control a linear or torque motor or a synchronous
spindle, the commutation (position of the field angle) needs to be reset for this motor.
Caution
The method to define the field angle of the respective axis / spindle is defined by the
machine manufacturer.
Follow the instructions of the machine manufacturer!
I would suggest extreme caution on this. MP 2340 and MP 2350 are the parameters where field angle is set. I have experience doing so in Siemens through the drive diagnostics, however, I did end up crashing the machine in the process (Linear motors and direct drive motors are EXTREMELY DANGEROUS when the field angle is not set properly- they run away and end up hitting the mechanical stops in a very uncontrolled fashion. This happened in my factory- The ATC door was squashed, not to mention the entire machine jumped and had to be relevelled. Mind you, the machine I am mentioning is 7 Tons in weight which jumped about a few inches. I learnt the hard way that the field angle NEEDS to be set.
My recommendation would be to contact Parpas (the machine tool maker who have made your machine) and they should be able to guide you over phone on how to set this.
Best of luck!
JSS
- Heidenhain iTNC 530 No field angle ESTERMA LINEAR with absolute encoders
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules