TNC 155 RS 232 parameters

[Hydralift]

Hi,
I have a TNC 155 which I have just repaired it and now I have to put the parameters. I have all the parameters except these that configure the RS232 port.
I use TNCserver for transferring the files. I use the TNCserver in mode ME send only and before it worked perfect but I do not remember the MP
Now I have put:
MP71: 515
MP218: 17736
MP219: 16712
MP220: 279
MP221: 5382
MP222: 168
MP223: 1 I tried also 0 with no sucess
MP224: 4
But these parameters do not work it says that the IN OUT device is not ready. Everything work perfect except that I cannot upload the programs.
Any idea what to change?

Similar Threads:

• Need Help!- DGN parameters Nakamura Tome TMC15M Fanuc OTC PMC-M how to enter PMC parameters?
• Need Help!- Parameters
• Need help with PMC parameters
• 3TC Parameters ????
• Parameters 281 and 282 on 0T

[machinehop5]

...this Thread might help ya.
https://www.cnczone.com/forums/machi...-software.html

Good luck on your mission,
DJ

[Hydralift]

I tried already all the mentioned solutions, zero results now it has new problem. When I connect the cable the TNC server software freeze and writes that is receiving data but this is not truth. when I disconnect the cable then the software respond again. I should mention also that I installed now a second control and again I have the same issue with the RS232. Is there any possibility the new control to need another cable connections from the previous? Could it be hardware problem? The machine works fine with the new control only the RS232 has problem. I tried all the solutions and parameters that I found on internet with no success. If the problem is the parameters then most probably I put something wrong so I need an advise from someone who has solved this problem in the past or from someone who know about TNC 155Q parameters. Any help is useful. Now I insert the programs by hand but it's not easy for big programs.