- Heidenhain Manual Plus
-
Member
-
-
Member
Re: Heidenhain Manual Plus
Dear Prefi,
You have to enable write access to the parameters, so you change parameter 5 to 1, so the control changes to English.
From “Manual Operation” (display with X and Z axis values via PROCESS and CURSOR button go to the INSTALLATION menu, where you choose the machine constants and approve with pressing ENTER.
In the softkey bar you can find the Operator-MC, press Softkey for Operator-MC. On the right side of the screen all operator constants for the machine will appear. Please go to machine constant N 80 with the CURSOR button, enter 1, in the bottom left field of the display C1 appears, please press buttons ENTER and STORE after another.
Machine constant N 80 now has the value 1 (that means Demo-Operation ON), please also see the register on the right side of the display.
Press PROCESS button and the control will reboot with the new parameters.
“Demo-Operation” active, you can now change all parameters.
Switch off “Demo-Operation”
Double check all settings!
Finally change the parameter N 80 to 0 again (C 0). If you press the PROCESS button the control will reboot again and all parameters will refresh and reinitialize. Now the changed parameters are active and the functional changes as well.
-
Member
Re: Heidenhain Manual Plus
II am looking for possibility changing the language this system. when im change parameter 7 on 10 machine not reaction at this change. What accept change? what parameter responsibility to change language (outside nr.5)
Last edited by RafalCNC; 03-16-2019 at 06:51 AM.
-
Member
Re: Heidenhain Manual Plus
Dear RafalCNC,
why change parameter 7? It's no. 5 for the language...
- Heidenhain Manual Plus
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules