Hello
Try and use cycle 427 consecutively.
The first touch point is the conductance ( saved in Q160)
Q60 = Q160; buffer conductance
Q61 = Q60 + 0,05 ; tolerance above
Q62 = Q60 - 0,05 ; tolerance below
Then you add the tolerance values after.
Hello everyone!
It’s about a DMF 260/7 with X Y Z B C axis and 3D measuring probe.
Is there a possibility to touch several points on the face and if the difference of these points in Z is giver than 0,05mm then the processing is automatically stopped/ or an error message is released.
Regards Lucas
Hello
Try and use cycle 427 consecutively.
The first touch point is the conductance ( saved in Q160)
Q60 = Q160; buffer conductance
Q61 = Q60 + 0,05 ; tolerance above
Q62 = Q60 - 0,05 ; tolerance below
Then you add the tolerance values after.
Gruß<br /><!--fonto:Comic Sans MS--><span style="font-family:Comic Sans MS"><!--/fonto-->Schwindl<!--fontc--></span><!--/fontc-->