No manual? - No problem there you can download it-
http://content.heidenhain.de/doku/tnc_guid.../670_388-20.pdf
... or simply use the help function on your controller.
Look TouchProbe cycle 403 and possibly also at cycle 419
Hello
I want to convey my pieces over the C-axis and then touch the zero point in X and Y (with TCH Probe).
Then save the zero point in the preset table
What’s the course of action for this process?
Unfortunately I have no manual? ?
@ FrankMa
No manual? - No problem there you can download it-
http://content.heidenhain.de/doku/tnc_guid.../670_388-20.pdf
... or simply use the help function on your controller.
Look TouchProbe cycle 403 and possibly also at cycle 419
Gruß / Regards
CNCFanatiker
AdminCrew
Wenn wir immer das tun was wir können, dann bleiben wir immer das was wir sind.
If we always this act what we are able to do, then we always remain what we are.