edit program blocks

Results 1 to 2 of 2

Thread: edit program blocks

  1. #1
    achsexyz's Avatar
    Join Date
    Jan 2012
    Location
    Dessau-Rosslau
    Posts
    15
    Downloads
    0
    Uploads
    0

    Default

    Hello
    I try to make sense of the demo version and I already have a problem.
    How can I edit single program block, where I want to change the data?
    For example when I called a cycle and I enter values that I want to change again afterwards.
    Also when I want to change a line for example.
    So far I always deleted the program block and then entered a new one with new values. I am sure that’s not the ideal solution... Please explain it “idiot-proof” as I am a beginner

    Thank you
    Michael



  2. #2
    Bender {MMO}'s Avatar
    Join Date
    Jan 2006
    Location
    s
    Posts
    314
    Downloads
    0
    Uploads
    0

    Default

    Hello

    When you press the combination Ctrl + Alt+4 on the computer at the programming station, then you get to the “program save/edit” mode. There you press Ctrl + Alt+P and you get to the PGM Manager. There you choose your program that you want to open and edit.
    Here you can select the block with the right arrow key on the keyboard. You get to the simulation with Ctrl + Alt+R. There you open again the PGM MGR and open the program that you want to simulate.


    Regards
    Manuel



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

edit program blocks

edit program blocks