CNC dont Move on F code

[reza703]

We buy a Bridgeport 5axis CNC milling MV 204 CU 15. I want some information and guidance about our machine. Would you please give me some help with CNC, for instance: User Manual, MP parameter, etc.?
In addition, I have a problem. My machine doesn't move (Spindle rotates) when I run programs and code arrived at F code; in contrast, it normally works when I use FMAX code.

Similar Threads:

• DRO's move but the servos dont
• 30/40 machine axis dont move?
• Need Help!- Steppers dont move.
• Need Help!- Takisawa MAC V4 with Fanuc 6M controller issues... motors dont move, position shows 0
• Need Help!- Y axis dont move

[dazp1976]

We buy a Bridgeport 5axis CNC milling MV 204 CU 15. I want some information and guidance about our machine. Would you please give me some help with CNC, for instance: User Manual, MP parameter, etc.?
In addition, I have a problem. My machine doesn't move (Spindle rotates) when I run programs and code arrived at F code; in contrast, it normally works when I use FMAX code.

Are you actually putting a feed rate number after the F or just putting a F only?

[reza703]

Yes, I put feed rate number after the F, for example, F2500

[reza703]

Are you actually putting a feed rate number after the F or just putting a F only?

CNC machine just works when using FMAX code instead of F2500

[reza703]

We buy a Bridgeport 5axis CNC milling MV 204 CU 15. I want some information and guidance about our machine. Would you please give me some help with CNC, for instance: User Manual, MP parameter, etc.?
In addition, I have a problem. My machine doesn't move (Spindle rotates) when I run programs and code arrived at F code; in contrast, it normally works when I use FMAX code.

This problem has been solved. Finally, I found the issue. It was solved by making a change in MP3010.

- - - Updated - - -

We buy a Bridgeport 5axis CNC milling MV 204 CU 15. I want some information and guidance about our machine. Would you please give me some help with CNC, for instance: User Manual, MP parameter, etc.?
In addition, I have a problem. My machine doesn't move (Spindle rotates) when I run programs and code arrived at F code; in contrast, it normally works when I use FMAX code.

This problem has been solved. Finally, I found the issue. It was solved by making a change in MP3010.