- Problem with new iTNC530
-
Registered
Hello
Thank you for entering in my post
I did download this software programming station. 340490 07 SP 3 as i had some problem with my old version
However I have a new problem which I didn't have with my old sofware that is: when I run a program in “Program, full sequence” I can see no graphic
I can't find the soft key: PGM, PGM+SECTS, PGM+STATUS, PGM+GRAPHICS, GRAPHICS, PGM+KINEMATICS, KINEMATICS
I can find them on TCNGuide of my software but not as soft key
thank you very much indeed again for your help
I really hope to hear from you soon again
Hoezap
-
- Problem with new iTNC530
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules