Problem different diameter graphic and tool table

Results 1 to 2 of 2

Thread: Problem different diameter graphic and tool table

  1. #1
    Registered arenamember's Avatar
    Join Date
    Dec 2012
    Location
    25
    Posts
    36
    Downloads
    0
    Uploads
    0

    Default

    Hello

    Thank you for entering in my post

    I can't understand why but suddenly the diameter I put on the tool table don't longer match with the diameter on the graphic when I test the program

    I did try to put even zero as diameter and it makes the same graphic as before

    I am going mad, may you please tell me what happened

    Thank you in advance for your help



  2. #2
    Administrator CNCFanatiker's Avatar
    Join Date
    Dec 2001
    Location
    EE-Kreis / Germany
    Posts
    5151
    Downloads
    1
    Uploads
    0

    Default

    Quote Originally Posted by arenamember View Post
    Hello

    Thank you for entering in my post

    I can't understand why but suddenly the diameter I put on the tool table don't longer match with the diameter on the graphic when I test the program

    I did try to put even zero as diameter and it makes the same graphic as before

    I am going mad, may you please tell me what happened

    Thank you in advance for your help
    Hello arenamember,

    make sure that the same tool table as well as in automatic mode also is activated in simulation.
    (look for status "M" & "S" of tool.t in the programm management)

    Gruß / Regards
    CNCFanatiker
    AdminCrew

    Wenn wir immer das tun was wir können, dann bleiben wir immer das was wir sind.
    If we always this act what we are able to do, then we always remain what we are.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Problem different diameter graphic and tool table

Problem different diameter graphic and tool table