Hardinge Conquest GT27 Fanuc 18t Control

[moso]

Looking for a Hardinge/Fanuc service engineer to sort out Main CPU board fault.
Machine will not boot, change the main board and same thing happened after 5 mins of power up.
had no chance to input parameters, I have now changed the power board, but have no main board to replace.
Get 4 green leds on top row (main board)
1 red led in bottom row.
Generic system Halt

Similar Threads:

• Need Help!- Hardinge GT27 Fanuc 18t Control lube problem
• Problem with C axis in Fanuc 18t - Hardinge Conquest t-51
• Need Help!- Hardinge Conquest T51 with fanuc 18T getting alarm 1020 Chuck open
• Need Help!- Re mapping X- Jog Arrow Hardinge GT27 Fanuc 18T
• Hardinge Quest GT27 Fanuc 18t

[::Andy::]

Looking for a Hardinge/Fanuc service engineer to sort out Main CPU board fault.
Machine will not boot, change the main board and same thing happened after 5 mins of power up.
had no chance to input parameters, I have now changed the power board, but have no main board to replace.
Get 4 green leds on top row (main board)
1 red led in bottom row.
Generic system Halt

Don't know if you have got this sorted since, but would highly recommend you get in touch with DNC Electronics near Swindon. Their tech people should be able to help you diagnose whats going on with your machine and either offer testing and inspection, or replacement boards.