Need parameters hardinge quest 6/42 build in 2003
Hello all
Just bought myself a hardinge quest 6/42 from a auction in Germany.
It is a ex us army Lathe with only 51 hours on the counter.
How this thing gets here in Europe I don't have a clue.
But now it's mine.
The backup battery is dead so I got a sram error.
And I only have a manual not a backup.
Can anyone here provide me with some parameters that might get the machine back working again.
Thanks in advance.
Kind regards from Holland
Similar Threads:
Re: Need parameters hardinge quest 6/42 build in 2003
Is it possible someone Stored the Par's on the HDD?
I see there is more than one Battery also. You didn't say what control you have but, I assume its Fanuc
http://www.hardingeservice.com/usr/Q...09500-0392.pdf
Battery replace on pdf page 41
http://www.hardingeservice.com/usr/Q...09500-0394.pdf
Re: Need parameters hardinge quest 6/42 build in 2003
The control is a 21it and does not have a HDD.
So i'm hoping on some parameters from you guys
There also might be a problem with the card reader because it won't read the card.
I have a original Fanuc Compact flash card 128MB.
I use this in my Hardinge GS250MSY with fanuc 18i control and there it works.
The machine is 5 years younger so there might be the problem.
So now i'm also figuring out if the control is the problem or the card.
I was looking at a post from someone on the internet the early fanuc 21it have problems with reading large Compact flash cards.
They advice a maximum 16mb Sram compact flash.
So there is some work more to do, then only get me the parameters.
Re: Need parameters hardinge quest 6/42 build in 2003
I would have thought it was the card reader I'll check my system and private message you
That would be great I assume you don't try it on a quest Lathe!Originally Posted by mbservice
Nobody? The machine is build in the USA so this is the right place right!
Reply with Quote
