CHNC1 Turret Encoder wiring?

[K_Labs]

FIXED IT!!!!! I pulled the cover off to check some voltages and one of the wires was unplugged. 6 wires come from the encoder. TB9-4,5,6,7,8 are all still hooked up. 5 out of the 6 wires are accounted for and I don't know where the black wire goes, Any and all help is appreciated I found an image from a different post but my wires don't match his pinout so I haven't tried it. What I do know is 5red,6oj,7yellow,8green are signal wires 4brownPos. and TB11-9blackNeg.

TB11-9 black Neg
TB9-4 brown Pos
TB9-5 red Signal
TB9-6 oj Signal
TB9-7 yellow Signal
TB9-8 green Signal

Similar Threads:

• Need Help!- turret servo/encoder question
• Takisawa TC1 turret encoder connection
• TURRET ENCODER
• HT20 TURRET ENCODER PROBLEM
• turret encoder

[Machineit]

Hope this helps!

Mike

P.S.: rereading it I guess it may not. Don't have time to pull covers right now, maybe later.

[K_Labs]

No need to pull your cover. Thanks for the quick response. I got it squared away. The machine is working great again.

[Machineit]

Good to hear---------

[Doggitter]

Hope this helps!

Mike

P.S.: rereading it I guess it may not. Don't have time to pull covers right now, maybe later.

Hi Machineit, do you have more of the diagrams for the CHNC2? Does it go more in depth inside the encoder itself by chance?