What size is the PCMIA Card ?
Does anyone have the procedure to do a full backup to include the ladder for the 21T controller?
I tried doing a backup to the pcmcia card in the controller and electrical cabinet. It did not recognize that there was a card there.
I have been able to back up what I can with the rs232 cable. I just can't seem to figure out how to get the ladder out of it.
Sent from my SM-G955U using Tapatalk
Similar Threads:
What size is the PCMIA Card ?
It looks like one of these.
Sent from my SM-G955U using Tapatalk
I have taken pictures of the various screens that will not punch out. That method will not help with the ladder though.
Sent from my SM-G955U using Tapatalk
I must have misunderstood what you are trying to do with the ladder ? The ladder for a cnc control is to show/explain where certain components are located and or if they are being used at a certain time . What is it that you are trying to do ? reload it into the system after a memory reset?
So how do you get the controller to back up to the SRam card?
Sent from my SM-G955U using Tapatalk
You put the SRAM card in the same place as you put the PCMIA card (on the I/O Board )
Then power up holding the two right hand soft keys under the screen