What model machine? Is it the newer VDI with a servo motor.
I have an early chnc and my turret only indexes to 4 positions. When any of the other 4 positions are called up the turret functions properly and turns but then it over shoots the position. I haven't had this machine very long and would like to know if anyone may have an idea what to look for.
Thanks,
Similar Threads:
What model machine? Is it the newer VDI with a servo motor.
Slow down air motor it may help.
I have most parts to your chnc cheap just make an offer ! Sold just the turret gear .
Thanks Ed
ed.murch@mamcomolding.com
There is a cover just behind turret . Remove and adjust sensor over the correct station . Just did this on my CHNC II
ed.murch@mamcomolding.com
i had an issue just yesterday where the turret would raise and just keep spinning, i swapped out the encoder and this did not fix the issue, next i changed the solenoid that stops the turret and once again this did not fix the issue. i found that the indexer motor has a valve, this piece upon inspection was full of what seemed to be rust from possible water in the system over the years. swapped part and all is good once again. hope this helps.
Went to put this machine back together and now my turret stop won’t actuate, anyone know what this may be ? Any help would be appreciated.