Hi, Not sure where to start diagnosing this.
I started the 2000 vintage Haas VF-0E after not using for a few weeks. Ran the spindle warm up then jogged the x, y, z & a axes .
Everything worked fine, I stopped for a minute and then no keys/ buttons worked at all. So I shutdown, waited a minute & restarted.
All that came up on the monitor was "garbled color" - so not blank ,but not good! and inputs did nothing.
I imagine there are previous posts about this happening but haven't found any yet.
Looking for any insights on where to start diagnosing this and /or links to info that may apply to this problem.
Thank You in advance,
Similar Threads: