Originally Posted by
R1_pilot
Hello.
Been getting an alarm whenever I try to pick up a tool from the umbrella while the spindle is empty.
I removed the filters on the solenoids and cleaned everything with the same results.
I think I narrowed it down to the tool unclamp switch to the right of the spindle. The switch works properly when I test it, but if there is no tool in the spindle the light stays on while I activate the unclamp switch. If there is a tool in the spindle and I press the tool release switch, the light goes off momentarily.
I am thinking whatever has to move in order to activate the switch, is not moving far enough when the tool is not in place. Could it be a broken spring? Or anything else?
Any help is appreciated. Thanks!