1992 Haas VF0


Results 1 to 4 of 4

Thread: 1992 Haas VF0

  1. #1
    Member Kubotaswapper's Avatar
    Join Date
    Oct 2019
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default 1992 Haas VF0

    I recently picked up this little Tupperware VF0 from a friends shop that was moving.

    Serial number is in the 1800’s, very early machine.

    Everything works after a couple adjustments and cleaning.
    7k spindle, rigid tap etc.

    This is mainly for my personal use. I have run haas machines for about 20years.

    Ran my first real part and found issues with my “y” axis.

    I interpolated a 7.13in diameter hole in a piece of aluminum.

    “X” was dead on 7.13 but “Y” measure 7.148. Approx .018 large.

    I still need to do a backlash test, and recently found that this machine has belt driven ball screws.

    Could this be from stretch?

    Thank you
    Ken

    Similar Threads:


  2. #2
    Member machinehop5's Avatar
    Join Date
    Aug 2009
    Location
    United States
    Posts
    1567
    Downloads
    5
    Uploads
    2

    Default Re: 1992 Haas VF0

    ...possible incorrect Backlash setting?



  3. #3
    Member Kubotaswapper's Avatar
    Join Date
    Oct 2019
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default Re: 1992 Haas VF0

    I will see if I can do backlash today. Hopefully it shows me something

    Ken



  4. #4

    Default Re: 1992 Haas VF0

    Check thrust bearings, mechanical backlash with a dti, and runout on the screw, of course dont change any params without saving the original values, and go from there, good luck.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

1992 Haas VF0

1992 Haas VF0