1992 Haas VF0
Member
1992 Haas VF0
I recently picked up this little Tupperware VF0 from a friends shop that was moving.
Serial number is in the 1800’s, very early machine.
Everything works after a couple adjustments and cleaning.
7k spindle, rigid tap etc.
This is mainly for my personal use. I have run haas machines for about 20years.
Ran my first real part and found issues with my “y” axis.
I interpolated a 7.13in diameter hole in a piece of aluminum.
“X” was dead on 7.13 but “Y” measure 7.148. Approx .018 large.
I still need to do a backlash test, and recently found that this machine has belt driven ball screws.
Could this be from stretch?
Thank you
Ken Similar Threads:
Member
Re: 1992 Haas VF0
...possible incorrect Backlash setting?
Member
Re: 1992 Haas VF0
I will see if I can do backlash today. Hopefully it shows me something
Ken
Member
Re: 1992 Haas VF0
Check thrust bearings, mechanical backlash with a dti, and runout on the screw, of course dont change any params without saving the original values, and go from there, good luck.
1992 Haas VF0
Tags for this Thread
Posting Permissions
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
Forum Rules