2010 TM-2.
It has the Ethernet option and I have set it up to successfully interact with a NAS share.
I also set up its own internal "ACCESS TO CNC SHARE" as "FULL" and can see it from my computer as (\\hhas-tm2).
From my computer, I can send files to it, edit them, rename them, etc (full access is turned on)
HOWEVER
I cannot see where the hell the files actually ARE on the mill!
I have:
"HARD DRIVE TAB ENABLED" set to ON but cannot see the HARD DRIVE tab.
I have:
"ENABLE HARD DRIVE" set to 1.
I looked as best as I could inside the control cabinet but could not find a hard drive (obviously it could be hidden).
The files are getting stored SOMEWHERE (presumably on a hard drive...).
I have searched through the forums and all over the Googles, and cannot find info on this.
Anyone have any ideas?
Thanks.