check Parameter 209 bit 31 (SPNDLE NOWAIT)
https://www.haascnc.com/content/dam/...ual---2002.pdf
PAGE 278-279
Vintage 1998 HAAS
When my tool holder grabs a tool and the spindle starts, there is a delay when set at any speeds above 2000 rpm, if I am doing an aggressive adaptive clearing I have to FEED HOLD right above work and wait about 5 sec for vfd to ramp up, if I dont it plows in, at low speed and then eventually alarms out shutting down. Anyone know why it would delay before going full rpm? I noticed this after losing my original HAAS .post file.
Similar Threads:
check Parameter 209 bit 31 (SPNDLE NOWAIT)
https://www.haascnc.com/content/dam/...ual---2002.pdf
PAGE 278-279
Thanks for the response, I cannot find that parameter even though its in my book, I am on the 209 par page also???
YW.
Did you use the? ............."The left and right cursor arrows are used to select the function being changed. All values
are 0 or 1 only."
DJ
I know how to change it, just cannot find that parameter on my list under 209