Haas VF help


Results 1 to 6 of 6

Thread: Haas VF help

  1. #1
    Member
    Join Date
    Mar 2013
    Location
    US
    Posts
    66
    Downloads
    0
    Uploads
    0

    Default Haas VF help

    Vintage 1998 HAAS
    When my tool holder grabs a tool and the spindle starts, there is a delay when set at any speeds above 2000 rpm, if I am doing an aggressive adaptive clearing I have to FEED HOLD right above work and wait about 5 sec for vfd to ramp up, if I dont it plows in, at low speed and then eventually alarms out shutting down. Anyone know why it would delay before going full rpm? I noticed this after losing my original HAAS .post file.

    Similar Threads:


  2. #2
    Member machinehop5's Avatar
    Join Date
    Aug 2009
    Location
    United States
    Posts
    1567
    Downloads
    5
    Uploads
    2

    Default Re: Haas VF help

    check Parameter 209 bit 31 (SPNDLE NOWAIT)
    https://www.haascnc.com/content/dam/...ual---2002.pdf
    PAGE 278-279



  3. #3
    Member
    Join Date
    Mar 2013
    Location
    US
    Posts
    66
    Downloads
    0
    Uploads
    0

    Default Re: Haas VF help

    Thanks for the response, I cannot find that parameter even though its in my book, I am on the 209 par page also???



  4. #4
    Member machinehop5's Avatar
    Join Date
    Aug 2009
    Location
    United States
    Posts
    1567
    Downloads
    5
    Uploads
    2

    Default Re: Haas VF help

    YW.

    Did you use the? ............."The left and right cursor arrows are used to select the function being changed. All values
    are 0 or 1 only."

    DJ



  5. #5
    Member
    Join Date
    Mar 2013
    Location
    US
    Posts
    66
    Downloads
    0
    Uploads
    0

    Default Re: Haas VF help

    I know how to change it, just cannot find that parameter on my list under 209



  6. #6
    Member
    Join Date
    Mar 2013
    Location
    US
    Posts
    66
    Downloads
    0
    Uploads
    0

    Default

    Quote Originally Posted by repauli1 View Post
    I know how to change it, just cannot find that parameter on my list under 209
    A work around I put a G4 P2500 right after the G54 move (Dwell 2500ms)



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Haas VF help

Haas VF help