Not sure if it’s compatible but I just pulled one of those “polyphase” transformers out of a VF1. It has the 4 sets of inputs to adjust voltage to 240.
Hello, does anyone have a haas mini mill with the 208-240 volt transformer and could you please send me a photo of their electrical cabinet including the transformer? I have a mini mill with the 360-480 high voltage transformer set up and need the part number off one that is 208-240 voltage. Thanks so much for any help getting this part number.
mech1atgsk
Not sure if it’s compatible but I just pulled one of those “polyphase” transformers out of a VF1. It has the 4 sets of inputs to adjust voltage to 240.
Part #64-1447
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Hello Mr. WMS,
Would you happen to have a photo of the electrical cabinet with that transformer included in the photo? I would like to see how its wired. I believe I will have to change the T5 Transformer and the Main breaker switch. The photo will confirm my research. Thanks
mech1atgsk
Hello Sam_Beckham,
Would you have a photo of the "polyphase" transformer? What year machine did it come from? Thank you
mech1atgsk
Sure..need any more let me know.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks to all replies...I just have not seen a machine yet that is close to my year model. Seems like they change some from year to year.
mech1atgsk