General quesion on Haas VMCs

[Bill_B]

Have a general question about how the models of Haas mills are structured. I've been looking at older VF0 VF1 and VF2 VMC mills from the late 90s early 80s as this is around where my budget is. 15K and under. My question is does the model dictate the table size?

Similar Threads:

• Are Haas VMCs Too Proprietary to Wire in a non-Haas 4th/5th Axis?
• Just IN- Carousel Disk for Haas VMCs
• General Haas VF Question
• haas - general opinion
• Quesion regarding inhibit jumper settings for Fanuc drive

[djr76]

Have a general question about how the models of Haas mills are structured. I've been looking at older VF0 VF1 and VF2 VMC mills from the late 90s early 80s as this is around where my budget is. 15K and under. My question is does the model dictate the table size?

VF0 26X14
VF1 26X14
VF2 36X14

You can find all the specs at haascnc

[Bill_B]

Thanks